Wireless Doorbells
For all Wireless Door Chimes
The beeping can be caused by two issues, depending on how the chime is powered. 1.Low or poor quality batteries Replace the batteries for new Alkaline or Lithium types to resolve the issue. If beeping remains please ensure the batteries are all new, eve...
If your bell push does not ring your doorbells when pressed then this could identify a few issues. In general: 1. Ensure the bell push battery is good quality and inserted the correct way around. The bell push should light up when pressed.* 2. If yo...
With most products, you can add additional door openers or doorbells to expand the system or replace parts. The table below shows which parts are compatible/exchangeable. You can check the model number of the system you are currently using on the back ...
It is not possible to change the frequency of the products, this will remain fixed at 433Mhz. With the older models however, in some ranges it was possible to change the code that the transmitter sends in order to avoid interference. P...
Depending upon the product range, bell push batteries required are either of the 'stubby' Alkaline type for the DBxxx and Bxxx ranges, or of the coin cell type for the BYxxx and DBYxxx range, as illustrated below; DBxxx and Bxxx ranges T...
How to install a wireless doorbell for the following models starting with DBY-21, DBY-22 and DBY-23.
Parts that are included in the box. The shape of the chime can be different per model, but the pairing procedure is the same. Tools that can be used for mounting the doorbell. How to start. Remove the cap from the door push of the ...
Parts which are included in the box. The shape of the chime can be different per model, but the pairing procedure is the same. Tools for mounting the plug-in doorbell. How to start. Remove the cap from the door push of the mounting plate. Do ...
It is not possible to reset earlier DB chime units, as such if a rogue signal is remotely activating the chime then a new up to date DB kit will be required as these later have a reset function built in, and the reset button is located next to the battery ...
If you have an SX, RX or TX model with dip switches, change the switches in the bell push to any new combination and also match the new combination inside the door chime unit. The older RX and TX ranges had 6 Dip switches, whereas the SX had 4 Dip switc...
To change the signal in an SXi bell push, simply remove the battery replace it back again. There are 256 different codes stored in the bell push and when it is powered back on again a new random code will be generated. The chime unit(s) will now also have...