Registering an administrator tag
An unregistered administrator tag is present.
Your doorbell is connected.
You have a small screwdriver to press the registration button.
1:
Press the registration button on the back of the outdoor module.
The LED will flash red.
2:
Run the unregistered administrator tag over the RFID sensor on the doorbell.
The device beeps several times to indicate that your administrator tag has been registered.
You can find the button under the yellow sticker as marked in the picture.
Registering a user tag
Your doorbell is in standby mode.
A registered administrator tag is present.
An unregistered user tag is present.
A door lock or door opener is connected. (Be sure to set the switch on the back of the outdoor module (doorbell) to open the gate or door.) See the "Connecting a door lock" section.
1:
Run your administrator tag over the RFID sensor on your doorbell.
2:
Press the call button within 10 seconds.
The LED flashes red and the device beeps.
3:
Now run your unregistered user tag over the RFID sensor on your doorbell.
4:
Press the call button to exit registration mode.
The device beeps several times to indicate that your tag has been registered.